Turbo PMAC2 VME Ultralite
Jumper Description 7
E17 – E18: Serial Port Select
E Point and
Physical Layout
Location Description Default
A-5 Jump E17 pin 1 to 2 to select RS-232 serial data
input from J5.
Jump E17 pin 1 to 3 to select RS-422 serial data
input from J5A.
Jump E17 pin 1 to 4 for future use of USB.
Pins 1 – 2 jumpered
A-5 Jump E18 pin 1 to 2 to select RS-232 serial
handshake input from J5.
Jump E18 pin 1 to 3 to select RS-422 serial
handshake input from J5A.
Jump E18 pin 1 to 4 for future use of USB.
Pins 1 – 2 jumpered
E19: Watchdog Disable Jumper
E Point and
Physical Layout
Location Description Default
E19
B-2 Jump pin 1 to 2 to disable Watchdog timer (for test
purposes only).
Remove jumper to enable Watchdog timer.
No jumper installed
E20 – E22: Power-Up/Reset Load Source
E Point and
Physical Layout
Location Description Default
E20
E22
C-4 Remove jumper E20.
Jump E21 pin 1 to 2.
Jump E22 pin 2 to 3 to read flash IC on power-
up/reset.
Other combinations are for factory use only;
the board will not operate in any other
configuration.
No E20 jumper installed;
E21 and E22 jump pin 1
to 2
E23: Firmware Reload Enable
E Point and
Physical Layout
Location Description Default
E23
C-4 Jump pin 1 to 2 to reload firmware through
serial or bus port.
Remove jumper for normal operation.
No jumper installed
E40: Electrical/Optical MACRO Input Select
E Point and
Physical Layout
Location Description Default
E16
A-2 Jump E16 pin 1 to 2 to select MACRO input
from fiber optic receiver.
Remove E16 jumper to select MACRO input
from electrical RJ45 receiver.
Jumper installed (Option
A)
No jumper installed
(Option C)
Comentarios a estos manuales