Delta Tau PMAC2A-PC/104 Manual descargar pdf (Pagina 52)

PMAC2A-PC104 Hardware Manual

Acc-1P E-Point Jumper Descriptions

46

E3 – E4: JHW, PD Function Select

E Point and Physical

Layout

Location Description Default

E3

E4

Jump pin 1 to 2 to enable handwheel

channel 1 inputs.

Jump pin 2 to 3 to enable pulse and

direction channel 1outputs.

1-2 Jumper

installed

E4

E4

Jump pin 1 to 2 to enable handwheel

channel 2 inputs.

Jump pin 2 to 3 to enable pulse and

direction channel 2 outputs.

1-2 Jumper

installed

E5: Servo Gate Address Select

E Point and Physical

Layout

Location Description Default

E5

E5

Jump pin 1 to 2 to address ACC-1P

channels at the regular addresses for

channels 5 to 8.

Jump pin 2 to 3 to address ACC-1P

channels at the regular addresses for

channels 5 to 8 plus $40.

1-2 Jumper

installed

E6: I/O Gate Address Select

E Point and Physical

Layout

Location Description Default

E6

E5

Jump pin 1 to 2 to address ACC-1P I/O

ports at the regular addresses.

Jump pin 2 to 3 to address ACC-1P I/O

ports at the regular addresses plus $40.

1-2 Jumper

installed

E7: Machine Input Source/Sink Control

E Point and Physical

Layout

Location Description Default

E7

E5

Jump pin 1 to 2 to apply +5V to input

reference resistor sip pack; this will

bias MI1 to MI8 inputs to +5V for

"OFF" state; input must then be

grounded for "ON" state.

Jump pin 2 to 3 to apply GND to input

reference resistor sip pack; this will

bias MI1 to MI8 inputs to GND for

"OFF" state; input must then be pulled

up for "ON" state (+5V to +24V).

1-2 Jumper

installed

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 71 72

Comentarios a estos manuales

Sin comentarios